Fitting Coroline Roofing Sheets

To install corrugated roofing start by cutting your panels to length with an angle grinder.

Fitting coroline roofing sheets.

Beginning at the outside edge of your roof place each panel directly onto the purlins that are attached to the roof trusses. Overhang the sheets at the fascia by 5cm to form a drip edge. Fitting sheets step 1. Next pre drill holes on the end and side ridges of the panels spacing the holes 6 to 8 inches apart.

Ensure the sheets are positioned square to the line of the eaves and verge first nailing the sheet edges. If cutting is necessary cut coroline sheets to length using a hand saw with a lubricating spray on the blade. Position and fix the verge barge board. Reduce the fixing centre to the first purlin up.

The order you install the panels should be dictated by the direction of the wind. Comprising corrugated bitumen sheets translucent pvc rooflight sheets ridge fixings and eaves fillers the coroline range provides the complete roofing solution. You should then lay your coroline panels along the lowest end and add rows above in the same direction as needed. Your first panel should be positioned at the furthest away point from the direction of the wind lowest end first.