They hold up your gutters and are connected to your soffits or the part below your gutters.
Fascia board demensions behind gutters.
Gutter brackets can be screwed directly into a replacement fascia board anywhere along its length using 25mm screws.
Next to a level fascia board the steeper the slope of the gutter the more it looks out of whack.
They are the strips situated at the point where the roof meets the outer wall of the house to cover the ends of the roofline.
Place your nails in line with the marks on your drip edge and place it in the center of your fascia board.
If the gutter is clogged some of that water will back up on the roof soaking it.
Drive 1 2 nails in per rafter so it doesn t move around.
Use 1 2 nails through each rafter to secure your fascia board.
Per 16 ft but this is not always possible.
Second it is in an area that is constantly wet or damp.
The fascia is commonly helps to hold up and stabilize gutters.
For starters this may not look good.
The board that rests behind your gutter is called a fascia board.
Sometimes also called soffit board fascia is a board running horizontally under a roof edge.
I think mine were 3 inch wide.
And it doesn t stop there.
Sometimes there are two fascia boards either the same width or different widths with a narrower board in front of a wider board and sometimes fascia is installed over a board of framing lumber called subfascia that mounts directly to the rafter tails.
Ideally gutters should slope down toward downspouts 1 in.
Pvc as a fascia material.
Left long enough the water runoff will cause damage to the roof shingles as well as your home s facade.
What is standard size of fascia board for gutters.
It covers the openings between the rafters of the roof.
The primary use of all fascia boards is to help secure the roof s gutter.
As long as there is a slight pitch say 1 2 in.
During house construction fascia boards are fastened to the ends of the rafters called rafter tails before the roofing and gutters are installed.
It lives with some unique problems.
Some of the water may leak behind the gutters down towards the soffit and the fascia.
I think mine were 3.
First since it s always covered by a gutter it is never exposed to sunlight.
4 or 6 inches would be better.
Third it never gets any paint.
When you last painted your house did you take your gutters down and paint behind them.
Replacement fascias do vary in thickness by manufacturer but the rule of thumb is that to qualify structurally as a replacement board they should be somewhere between 16mm and 25mm thick our most common range is the 18mm replacement fascia.
Hold the board in place and use 2 in 5 1 cm nails and a hammer to secure it in place.
If you are hanging gutters on the fascia you will probably want ot go with something a bit larger than 3 inches.
